Electric rolling shutter door common faults and maintenance methods

Electric Rolling Shutter Door is a common Automatic Door switch equipment, which has been widely used in modern architecture and industry. They offer a high level of security and privacy, while also reducing energy consumption and maintenance costs. However, there may be some faults in the use of electric shutter doors. The following are some common faults and their maintenance methods:

1. Can not run normally: the electric shutter door can not run normally, at this time, you need to check the remote control battery to ensure that the remote control is in normal working state. If the problem with the remote control continues, you need to further check whether the motor, relay (contactor), micro switch or contact plate, transmission gear, ring chain or chain oil, brake disc or adjustment balance, pump, grease and other components are working properly. If any damaged parts are found, they should be replaced promptly.

2. The door panel is stuck: The door panel of the electric shutter door is stuck and cannot be closed or opened normally. This condition can be caused by dust, dirt or other debris on the door panel. At this time, you need to use professional cleaning tools and cleaners to clean the door panel to ensure that the surface of the door panel is clean and tidy.

3. Door panel tilt: The electric shutter door panel tilt, resulting in the door panel can not be closed or opened normally. This condition may be due to the incorrect installation position of the door panel or the failure of the balance system of the door panel. In this case, adjust the installation position of the door panel to ensure that the door panel is horizontal. If the balance system of the door panel is faulty, replace the balance system components.

4. Excessive noise of the door panel: The noise of the door panel of the electric rolling shutter door is too large, which may be due to the incorrect installation position of the door panel or the failure of the door panel balance system. In this case, adjust the installation position of the door panel to ensure that the door panel is horizontal. If the balance system of the door panel is faulty, replace the balance system components.

5. The door panel cannot rise and fall normally: The door panel of the electric rolling shutter door cannot rise and fall normally, which may be due to the failure of the drive system of the door panel. At this time, it is necessary to check the various components of the drive system, such as the motor, transmission gear, chain, etc., to ensure that they are in normal working condition. If any damaged parts are found, they should be replaced promptly.

In short, the fault and maintenance methods of the electric shutter door need to be analyzed and processed according to the specific situation. If you encounter any problems, it is recommended that you contact professional electric shutter door maintenance personnel in time for processing.