What factors cause the stainless steel electric telescopic door to deviate?

What factors cause the stainless steel Electric Telescopic Door to deviate? Haifeng Door Industry would like to introduce you to:

Firstly, we need to know whether the stainless steel electric telescopic door is monorail or trackless, and then we need to determine whether the motor chain is loose. If a loose chain is found, it is necessary to adjust the motor chain at this time.

Then check if there are any issues with the motor and control system, including the setting of control system parameters. If the door body is relatively tight, it can lead to improper assembly and poor operation of the door body. At this point, you only need to adjust the tightness of the main frame of the door body.

Then we need to see if the weight of the head substrate is just right, because many small manufacturers now replace the weight of the head substrate to reduce costs. For example, a 15 meter car door comes standard with an 8-centimeter plate, but only a 3-centimeter plate, which can lead to a reduction in nose traction and cause problems.

In fact, not all styles of stainless steel electric telescopic doors are suitable for trackless doors, but some unprofessional small manufacturers may think that any style is acceptable without any restrictions, but there are actually technical regulations. The most important thing is that the door head of the door body must be parallel. In addition, grounding issues also need to be considered, which is a very important issue. If the ground is tilted or uneven, it can cause the stainless steel electric telescopic door to deviate.

In addition, we also need to check if the guide rail of the stainless steel electric telescopic door is damaged. If damaged, the ring needs to be replaced. If the motor drive power is insufficient or the gate arrangement is too compact, it can also lead to difficulty in operating the machine head. In this way, it is recommended to adjust the tightness of the door truss. There is also a possibility that the machine head was manually pushed. In this case, the telescopic door can return to its position without any adjustment. If it is a trackless operation, it may be due to too few magnets or too large spacing. It is recommended to add a magnetic rod in this way.