Electric translation automatic door

Electric translation Automatic Door

With the development of The Times, automatic door is more and more people choose, it is not only beautiful and practical, but also very convenient to use.

Now people like to install automatic glass doors, not only for aesthetics, but also because it is convenient and generous. More convenient access. At present, most of the doors are used in public places. Therefore, many people are very interested in the principle of automatic doors. In addition, in the installation of automatic doors, should pay attention to the method. Only by understanding these, can we better install automatic doors.Quick Roll-up Door

1. Main controller: control center of automatic door. Through a large integrated block with an instruction program, issue corresponding instructions to command the motor or electric lock system to work; At the same time, people adjust the opening speed and opening range of the door through the main controller.

2. Induction detector: responsible for collecting external signals, such as human eyes. When the moving object enters its working range, it sends a pulse signal to the master controller; Power motor: provides the main force to open and close the door, and controls the acceleration and deceleration of the door panel.

3. Door-leaf walking tracks: Like train tracks, the door-leaf lifting wheel system is restricted to moving and sliding in specific directions. Door and leaf lifting wheel system: Used to suspend movable door leaf and drive door leaf to run under power traction.

4. Synchronous belt (or v belt): used to transfer the power generated by the motor to drive the wheel train of the door and leaf spreader. Lower guide system: located

A guiding and positioning device on the lower part of the door to prevent the front and rear doors from swinging while working.

1. The upper and lower door shafts must be in a vertical line. Automatic door must use steel structure beam as the frame, the upper shaft must be welded to the beam. Because the door shaft is the fulcrum of the entire automatic door, it must be firm. It is forbidden to use the construction of the beam on the fine plank wood keel, because the connection points of the upper dowel shaft and the wood structure can only be secured with self-tapping screws, making the upper dowel shaft easy to fall off for a long time, causing danger.

2. When the spring is embedded, a rectangular square pit should be chiselled on the in-situ surface, and the surrounding area should be greater than 10mm of the ground spring foundation, which is used to block the high grade cement mortar and play a stable role. It is recommended to install the automatic door according to the cement curing 48 hours after the automatic door, the ground edge is 8-12mm away from the ground, to prevent the automatic door sinking against the ground.Sensor Door

3. The upper and lower axis of the door should be located in the center of the door frame, so that the automatic door can also be located in the center of the door frame after installation, play a beautiful effect. The edge of the glass door is 3-6 mm away from the beam to prevent the door shaft from separating from the connecting part of the door clamp when the door falls. There is one more detail that needs to be noted. The location of door shaft and door clamp should be grease, which can reduce joint wear and prolong service life.Industrial Doors

Shenzhen Haifeng Mechanical and Electrical Equipment Co., Ltd. is located in Gongming Street, Guangming District, Shenzhen City, Guangdong Province. Founded in 2002, it is a high-tech door automation company committed to developing into the world's advanced door technology. Mainly engaged in Quick roll-up door, Quick Door, Automatic door, Automatic Induction Door, automatic flat door, automatic overlapping door, Medical Automatic Door, arc automatic door, rotary automatic door, stainless steel automatic door, fast rolling shutter door, industrial stacking door, industrial rolling shutter door, electric expansion door, crystal rolling shutter door, electric rolling gate, all kinds of door control motor, car park license plate recognition system series and computer, mobile phone peripheral series of electronic products. The strength of the company is strong. With first-class personnel, first-class equipment, first-class plant, first-class technology. The company has been the product quality as the lifeblood of the company, from each production link, each process, follow the ISO quality management system rules, strictly good quality, and strive to produce 100% qualified rate.